Metadata: Identification_Information: Citation: Citation_Information: Originator: USDA-FSA-APFO Aerial Photography Field Office Publication_Date: 20131105 Title: NAIP Digital Ortho Photo Image Geospatial_Data_Presentation_Form: remote-sensing image Publication_Information: Publication_Place: Salt Lake City, Utah Publisher: USDA-FSA-APFO Aerial Photography Field Office Description: Abstract: This data set contains imagery from the National Agriculture Imagery Program (NAIP). The NAIP program is administered by USDA FSA and has been established to support two main FSA strategic goals centered on agricultural production. These are, increase stewardship of America's natural resources while enhancing the environment, and to ensure commodities are procured and distributed effectively and efficiently to increase food security. The NAIP program supports these goals by acquiring and providing ortho imagery that has been collected during the agricultural growing season in the U.S. The NAIP ortho imagery is tailored to meet FSA requirements and is a fundamental tool used to support FSA farm and conservation programs. Ortho imagery provides an effective, intuitive means of communication about farm program administration between FSA and stakeholders. New technology and innovation is identified by fostering and maintaining a relationship with vendors and government partners, and by keeping pace with the broader geospatial community. As a result of these efforts the NAIP program provides three main products: DOQQ tiles, Compressed County Mosaics (CCM), and Seamline shape files The Contract specifications for NAIP imagery have changed over time reflecting agency requirements and improving technologies. These changes include image resolution, horizontal accuracy, coverage area, and number of bands. In general, flying seasons are established by FSA and are targeted for peak crop growing conditions. The NAIP acquisition cycle is based on a minimum 3 year refresh of base ortho imagery. The tiling format of the NAIP imagery is based on a 3.75' x 3.75' quarter quadrangle with a 300 pixel buffer on all four sides. NAIP quarter quads are formatted to the UTM coordinate system using the North American Datum of 1983. NAIP imagery may contain as much as 10% cloud cover per tile. Purpose: NAIP imagery is available for distribution within 60 days of the end of a flying season and is intended to provide current information of agricultural conditions in support of USDA farm programs. For USDA Farm Service Agency, the 1 meter and 1/2 meter GSD product provides an ortho image base for Common Land Unit boundaries and other data sets. The 1 meter and 1/2 meter NAIP imagery is generally acquired in projects covering full states in cooperation with state government and other federal agencies that use the imagery for a variety of purposes including land use planning and natural resource assessment. The NAIP is also used for disaster response. While suitable for a variety of uses, prior to 2007 the 2 meter GSD NAIP imagery was primarily intended to assess "crop condition and compliance" to USDA farm program conditions. The 2 meter imagery was generally acquired only for agricultural areas within state projects. Time_Period_of_Content: Time_Period_Information: Single_Date/Time: Calendar_Date: 20130701 Currentness_Reference: Ground Condition Status: Progress: Complete Maintenance_and_Update_Frequency: Irregular Spatial_Domain: Bounding_Coordinates: West_Bounding_Coordinate: -88.3750 East_Bounding_Coordinate: -88.3125 North_Bounding_Coordinate: 45.1250 South_Bounding_Coordinate: 45.0625 Keywords: Theme: Theme_Keyword_Thesaurus: None Theme_Keyword: farming Theme_Keyword: Digital Ortho rectified Image Theme_Keyword: Ortho Rectification Theme_Keyword: Quarter Quadrangle Theme_Keyword: NAIP Theme_Keyword: Aerial Compliance Theme_Keyword: Compliance Place: Place_Keyword_Thesaurus: Geographic Names Information System Place_Keyword: WI Place_Keyword: Oconto Place_Keyword: 55083 Place_Keyword: WI083 Place_Keyword: OCONTO CO WI FSA Place_Keyword: 4508862 Place_Keyword: HICKORY CORNERS, NW Place_Keyword: HICKORY CORNERS Access_Constraints: There are no limitations for access. Use_Constraints: None. The USDA-FSA Aerial Photography Field office asks to be credited in derived products. Point_of_Contact: Contact_Information: Contact_Organization_Primary: Contact_Organization: Aerial Photography Field Office (APFO) Contact_Address: Address_Type: mailing and physical address Address: 2222 West 2300 South City: Salt Lake City State_or_Province: Utah Postal_Code: 84119-2020 Country: USA Contact_Voice_Telephone: 801-844-2922 Contact_Facsimile_Telephone: 801-956-3653 Contact_Electronic_Mail_Address: apfo.sales@slc.usda.gov Browse_Graphic: Browse_Graphic_File_Name: None Browse_Graphic_File_Description: None Browse_Graphic_File_Type: None Native_Data_Set_Environment: Data_Quality_Information: Logical_Consistency_Report: NAIP 3.75 minute tile file names are based on the USGS quadrangle naming convention. Completeness_Report: None Positional_Accuracy: Horizontal_Positional_Accuracy: Horizontal_Positional_Accuracy_Report: NAIP horizontal accuracy specifications have evolved over the life of the program. From 2003 to 2004 the specifications were as follows: 1-meter GSD imagery was to match within 3-meters, and 2-meter GSD to match within 10 meters of reference imagery. For 2005 the 1-meter GSD specification was changed to 5 meters matching the reference imagery. In 2006 a pilot project was performed using true ground specifications rather than reference imagery. All states used the same specifications as 2005 except Utah, which required a match of +/- 6 meters to true ground. In 2007 all specifications were the same as 2006 except Arizona used true ground specifications and all other states used reference imagery. In 2008 and subsequent years no 2-meter GSD imagery was acquired and all specifications were the same as 2007 except approximately half of the states acquired used true ground specifications and the other half used reference imagery. The 2008 states that used absolute ground control where; Indiana, Minnesota, New Hampshire, North Carolina, Texas, Vermont, and Virginia. From 2009 to present all NAIP imagery acquisitions used the +/- 6 meters to ground specification. Lineage: Source_Information: Source_Citation: Citation_Information: Originator: USDA-FSA-APFO Aerial Photography Field Office Publication_Date: 20131105 Title: HICKORY CORNERS, NW Geospatial_Data_Presentation_Form: remote-sensing image Type_of_Source_Media: UnKnown Source_Time_Period_of_Content: Time_Period_Information: Single_Date/Time: Calendar_Date: 20130701 Source_Currentness_Reference: Aerial Photography Date for aerial photo source. Source_Citation_Abbreviation: Georectifed Image Source_Contribution: Digital Georectifed Image. Process_Step: Process_Description: DOQQ Production Process Description USDA FSA APFO NAIP Program 2013 State: Wisconsin Digital imagery was collected at a nominal GSD of 1.0m using seven Cessna 441 aircrafts flying at an average flight height of 9052m AGL. All aircraft flew with Leica Geosystem's ADS80/SH82 digital sensors with firmware 3.20 or newer. Each sensor collected 11 image bands. PanF27A,PanF02A and PanB14A panchromatic bands with a spectral range of 465-676nm. RedN00a and RedB16a with a spectral range of 604-664nm. GrnN00a and GrnB16a with a spectral range of 533-587nm. BluN00a and BluB16a with a spectral range of 420-492nm and Near-infrared bands NirN00a and NirB16a with a spectral range of 833-920nm. The CCD arrays have a pixel size of 6.5 microns in a 12000x1 format. Both the CCD's and the A/D convertors have a dynamic range of 12bits. The data is stored in 16bit format. The ADS is a push-broom sensor and the ground footprint of the imagery at NAIP scale is 12km wide by the length flightline. The maximum flightline length is limited to approximately 240km. The factory calibrations and IMU alignments for each sensor (Serial Numbers: 1321, 1413, 1420, 30012, 30017, 30022, 30034, and 30110) were tested and verified by in-situ test flights before the start of the project. The Leica ADS Flight Planning and Evaluation Software (FPES) is used to develop the flight acquisition plans. Flight acquisition sub blocks are designed first to define the GNSS base station logistics, and to break the project up into manageable acquisition units. The flight acquisition sub blocks are designed based on the specified acquisition season, native UTM zone of the DOQQs, flight line length limitations (to ensure sufficient performance of the IMU solution) as well as air traffic restrictions in the area. Once the sub blocks have been delineated they are brought into FPES for flight line design. The design parameters used in FPES will be 30% lateral overlap and 1.0m resolution. The flight lines have been designed with a north/south orientation. The design takes into account the latitude of the state, which affects line spacing due to convergence as well as the terrain. SRTM elevation data is used in the FPES design to ensure the 1m GSD is achieved over all types of terrain. The raw data was downloaded from the sensors after each flight using Leica XPro software. The imagery was then georeferenced using the 200Hz GPS/INS data creating an exterior orientation for each scan line (x/y/z/o/p/k). Technicians precisely measured tie points in 3 bands/looks (Back/Nadir/Forward) for each line using Leica Xpro software. The resulting point data and exterior orientation data were used to perform a full bundle adjustment with ORIMA software. Blunders were removed, and additional tie points measured in weak areas to ensure a robust solution. Once the point data was clean and point coverage was acceptable, photo-identifiable GPS-surveyed ground control points were introduced into the block adjustment. The bundle adjustment process produces revised exterior orientation data for the sensor with GPS/INS, datum, and sensor calibration errors modeled and removed. Using the revised exterior orientation from the bundle adjustment, orthorectified image strips were created with Xpro software and the April 2013 USGS 10m NED DEM. The Xpro orthorectification software applies an atmospheric-BRDF radiometric correction to the imagery. This correction compensates for atmospheric absorption, solar illumination angle and bi-directional reflectance. The orthorectified strips were then overlaid with each other and the ground control to check accuracy. Once the accuracy of the orthorectified image strips were validated the strips were then imported into Inpho's OrthoVista 4.6 package which was used for the final radiometric balance, mosaic, and DOQQ sheet creation. The final DOQQ sheets, with a 300m buffer and a ground pixel resolution of 1m. Process_Date: 20131105 Spatial_Data_Organization_Information: Indirect_Spatial_Reference: Oconto County, WI Direct_Spatial_Reference_Method: Raster Raster_Object_Information: Raster_Object_Type: Pixel Row_Count: 1 Column_Count: 1 Spatial_Reference_Information: Horizontal_Coordinate_System_Definition: Planar: Grid_Coordinate_System: Grid_Coordinate_System_Name: Universal Transverse Mercator Universal_Transverse_Mercator: UTM_Zone_Number: 16 Transverse_Mercator: Scale_Factor_at_Central_Meridian: 0.9996 Longitude_of_Central_Meridian: -87.0 Latitude_of_Projection_Origin: 0.0 False_Easting: 500000 False_Northing: 0.0 Planar_Coordinate_Information: Planar_Coordinate_Encoding_Method: row and column Coordinate_Representation: Abscissa_Resolution: 1 Ordinate_Resolution: 1 Planar_Distance_Units: meters Geodetic_Model: Horizontal_Datum_Name: North American Datum of 1983 Ellipsoid_Name: Geodetic Reference System 80 (GRS 80) Semi-major_Axis: 6378137 Denominator_of_Flattening_Ratio: 298.257 Entity_and_Attribute_Information: Overview_Description: Entity_and_Attribute_Overview: 32-bit pixels, 4 band color(RGBIR) values 0 - 255 Entity_and_Attribute_Detail_Citation: None Distribution_Information: Distributor: Contact_Information: Contact_Person_Primary: Contact_Person: Supervisor Customer Services Section Contact_Organization: USDA-FSA-APFO Aerial Photography Field Office Contact_Address: Address_Type: mailing and physical address Address: 2222 West 2300 South City: Salt Lake City State_or_Province: Utah Postal_Code: 84119-2020 Country: USA Contact_Voice_Telephone: 801-844-2922 Contact_Facsimile_Telephone: 801-956-3653 Contact_Electronic_Mail_Address: apfo.sales@slc.usda.gov Distribution_Liability: In no event shall the creators, custodians, or distributors of this information be liable for any damages arising out of its use (or the inability to use it). Standard_Order_Process: Digital_Form: Digital_Transfer_Information: Format_Name: Format_Information_Content: Multispectral 4-band Digital_Transfer_Option: Offline_Option: Offline_Media: CD-ROM Recording_Format: ISO 9660 Mode 1 Level 2 Extensions Offline_Option: Offline_Media: DVD-R Recording_Format: ISO 9660 Offline_Option: Offline_Media: USB Hard Disk Recording_Format: NTFS Offline_Option: Offline_Media: FireWire Hard Disk Recording_Format: NTFS Fees: Contact the Aerial Photography Field Office for more information Resource_Description: m_4508862_nw_16_1_20130701_20131029.tif Metadata_Reference_Information: Metadata_Date: 20131105 Metadata_Contact: Contact_Information: Contact_Organization_Primary: Contact_Organization: USDA-FSA-APFO Aerial Photography Field Office Contact_Address: Address_Type: mailing and physical address Address: 2222 West 2300 South City: Salt Lake City State_or_Province: Utah Postal_Code: 84119-2020 Country: USA Contact_Voice_Telephone: 801-844-2922 Metadata_Standard_Name: Content Standard for Digital Geospatial Metadata Metadata_Standard_Version: FGDC-STD-001-1998